Prepare flash trigger with a radio receiver
NOTE:
Pay attention to the user manual of the radio trigger manufacturer.
Plug cable of the radio receiver into the connective socket 3.5mm for the
sync cable on the device.
Connect radio transmitter to hot shoe of camera.
10.
Trigger flash
Switch on device. See
Switch device on and off
.
For check, trigger device with the test button (on the powerpack or on the
radio remote trigger).
Trigger flash according to the prepared method of flash trigger.
See
Prepare and adjust flash trigger.
11.
Transportation and storage of the device
Switch off device.
See
Switch device on and off
.
Allow for device to cool down completely.
WARNING!
Danger of fire due to hot device components. Allow for
device to cool off completely.
Demount connecting cables.
Clean the device if necessary. See
Cleaning of the device.
Put the device and all demounted elements into the original Styrofoam
packaging and transport and store them according to the requirements in
the technical specifications. See
Technical specifications.
12.
Solve problems
Problem
Possible cause
Solution
Device is switched on
but shows no function
Battery is not or not
sufficiently
charged/defective
Charge/exchange
battery
Flash shows function
but triggering a flash is
not possible
Powerpack or flash
device is defective
Contact Foto Walser
customer service
Flash tube is broken
Replace flash tube, if
needed with electrically
qualified person
13.
Maintenance of the device
13.1.
Continuous inspection and maintenance of the device
What you should do
Before each use
Check all cables and plugs for damages
.
If damaged
:
WARNING!
Danger of electric shock and fire due to
short-circuit
Have the device/charger repaired by an electrician
immediately.
X
16
17
