PPG Wave 2.V
Waldorf
14
Operation Manual
QUAD and MONO modes, voices are equally spread within the stereo spectrum. This
function only makes sense, if you monitor your audio signal in stereo.
���
In contrast to the original PPG, where it could happen that two voice would
sound on the same channel, voices in the PPG Wave 2.V always sound alternati-
vely for each channel.
VOLUME
0...63
This dial is used to set the output volume of a Program. It is a good idea to the lower
the Volume value, if the sound tends to distort anyway because of its settings. In Pro-
gram mode, this allows you to use sounds with different volumes.
���
VOLUME is not Master-Volume, it only applies to the respective MIDI channel.
Use the channel mixer in your host-application, if you want to reduce the overall
volume of the Plug-In.
LFO
LFO (Low Frequency Oscillator) is an oscillator that creates
an oscillation below the threshold of audibility. These can be
used to continuously control different parameters (e.g. to
control the WAVES, the FILTER or the pitch of the oscillator).
The PPG Wave 2.V’s LFO offers four different oscillator
waveforms as modulation signal. modulation intensity can be controlled with the Mo-
dulation wheel (MODWHEEL). If it is fully turned down, no modulation takes place.
Same as on the original PPG Wave synth, the Modulation wheel setting is saved with
each Program. Make sure that TOUCH>MOD in the MODULATION menu is set to
OFF, otherwise the LFO will only modulate the signal if Aftertouch data is generated at
the same time.
The LFO can also be synchronized to the Song tempo of your host application.
���
The original PPG LFOs were calculated with a very low update rate, as back
then, the available processor power had to be carefully distributed to the various
tasks. In the PPG Wave 2.V you can get this low update rate, if you activate TRUE
PPG.
DELAY
0...63
This parameter enables a smooth LFO modulation intensity attack.
���
If TRUE PPG is deactivated, DELAY doesn’t have an impact when set to zero. If
TRUE PPG is active, the LFO is faded in with any new key that you press, ir-
respective of the DELAY parameter setting.
WAVESHAPE
Triangle, Saw down, Saw up, Square
The LFO can create the following four waveforms: Triangle, falling saw tooth, rising
saw tooth and Square. You can use this control to select one of these waveforms.
Содержание PPG Wave 2.V
Страница 1: ......