The following diagram shows how this example works:
☞
This is how you setup an envelope that it works like a sawtooth LFO with different
rates in the sustain and release phase:
1. Set
Key On Loop
and
Key Off Loop
to
on. This causes both loops in the sustain
and in the release phase to be activated.
2. Set
Level 1
and
Time 1
to
0. This deactivates segment 1 because it can not be
looped.
3. Set
Level 2
to
127. This defines the maximum value of the sawtooth’s amplitude.
4. Specify the rate of the sawtooth for the sustain phase via the
Time 2
parameter.
5. Set
Key On Loop Start
to
1 and
Key On Loop End
to
2. This will repeat
segment 2 of the envelope as long as the key is pressed.
6. Set
Level 3
to
0. This defines the minimum setting of the sawtooth’s amplitude.
7. Set
Time 3
to
0. This causes the envelope abruptly to minimum level after
releasing the key and sets the minimum value of the sawtooth’s amplitude in the
release phase.
8. Set
Level 4
to
127. This defines the maximum value of the sawtooth’s amplitude
in the release phase.
9. Specify the rate of the sawtooth for the release phase via the
Time 4
parameter.
10. Set
Key Off Loop Start
to
3 and
Key Off Loop End
to
4. This will repeat
segment 4 of the envelope in the release phase.
The following diagram shows how this example works:
Time 1 = 0
Level 1 = 0
Time 2
Level
Time
Key pressed
Key released
Time 4
Time 3 = 0
Level 3 = 0
Level 2 = 127
Level 4 = 127
1
2
3
4
Key On Loop Start = 1
Key On Loop End = 2
Key Off Loop Start = 3
Key Off Loop End = 4
Time 1
Level
Time
Key pressed
Key released
Time 2
Level 1 = 127
1
3
Key On Loop End = 2
Key Off Loop End = 3
2
Time 3
Level 2
Level 3 = 0
76
User’s Manual MicroWave II • MicroWave XT • XTk
Содержание MicroWave II
Страница 1: ...Bedienungsanleitung User s Manual ...
Страница 2: ......
Страница 123: ......
Страница 125: ......
