Waldorf GP8910GE, Инструкция по установке и эксплуатации

Страница: 26 / 32

24
Gas Conversion and Specifications
8. Refit the front control panel and tighten the 2 screws on the underside to secure the panel in place.
9. Refit the control knobs to the front control panel. The control knobs are a push fit onto the shafts of
the gas control valves.
Low Fire Adjustment - (Gas Griddle)
To change the gas griddle thermostat ‘Low Fire’ adjustment, the low fire screw on the gas control valve
should be screwed fully in, then unscrewed by 1 full turn as shown in the ‘Gas Specifications’ table at the
end of this section.
1.
Remove the griddle gas control knob from the front
control panel. The knob is a push fit onto the shaft of
the gas control valve.
2. Remove the gas griddle control panel from the front
of the gas griddle by removing the 2 securing screws
in the lower corners of the panel.
3. Screw the ‘Low Fire’ screw fully ‘IN’ and then unscrew
by 1 Full Turn of the ‘Low Fire’ screw. (Refer to the
‘Gas Specification’ table at the rear of this section).
4. Ensure that the Gas Control Pilot Screw is adjusted to 3 turns out c.c.w.
5. Refit the control panel and secure with the securing
screws.
6. Refit the gas control knob to the shaft of the gas control valve.
NOTE: The ‘Low Fire Screw’ should be sealed with coloured paint on completion of the low fire
adjustment.
Low Fire
Adjustment Screw
Fig 10