24
Mounting
ENG
3. Mounting
CAUTION
Risk of injury caused by the device
falling down.
Personal injury and material damage.
X
Use only suitable fastening ele-
ments available from the manufac-
turer.
X
Mount fastening elements cor-
rectly.
3.1 Dimensions
a
c
b
No.
Dimensions
a
115 mm
b
26.5 mm
c
25 mm
Tab. 2: Dimensions.
3.2 Mounting the device
Determining a position
X
LTS/ST
: Position the switch such that
it is easy to operate.
X
LDS/ST
: Position the centre of the sen-
sor
B
at a distance of 3.5 cm to 130 cm
from the object to be detected, see
NOTE:
In the factory setting, the sensor
of the LDS/ST device is set to a distance
of 10 cm. This setting can be changed, see
section “Setting the distance”, page 30.
Mounting the fastening elements
NOTES:
The two outer fastening elements must
be mounted to the mounting surface at a
distance of
The tolerance range of the holders, rel-
ative to the fastening elements, is in
each case ±15 mm.
For mounting the fastening elements,
flat-headed screws must be used that
are suitable for the respective mount-
ing surface. These screws may have a
maximum shaft diameter of 4 mm, a
maximum head diameter of 8 mm and
a maximum head height of 3.5 mm.
For mounting the fastening elements
to metal sheets, suitable self-tapping
screws can be found in the scope of
delivery of the device.
a - 30
mm
A
Fig. 3: Mounting the fastening elements.
X
Mount the fastening elements
A
to the
mounting surface in parallel to each
other using suitable screws, see Fig. 3.
