Wahuda 50200PC-WHD, Руководство пользователя

Страница: 14 / 41

14
ASSEMBLY (cont)
TABLE MAGNETS
The table magnets keep the tables from falling during transport of the planer.
The 2 long table magnets, item H page 12, should be screwed into the threaded holes on the front
of the cutterhead assembly and tightened with a Phillips screwdriver (not supplied)
See picture on page 4 for reference.
The 2 short table magnets, item I page 12, are optional. They can be threaded into the inner holes
on the rear of the cutterhead assembly only when the dust port is removed.
ADJUSTMENTS
WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE
POWER SOURCE BEFORE ANY ADJUSTMENTS ARE MADE.
WARNING! BE VERY CAREFUL WORKING NEAR THE CUTTERHEAD INSERT TIPS. THEY
ARE EXTREMELY SHARP AND CAN CAUSE INJURY.
LEVELING INFEED AND OUTFEED TABLES
The infeed and outfeed tables must be parallel and level with the planer center wear plate located
under the cutterhead assembly. These have been preset at the factory but may need
readjustment.
Using the crank handle, raise the cutterhead assembly to its highest position. Being extremely
careful of the cutterhead insert tips, lay a metal straight edge on the infeed table and center wear
plate at both left and right sides of the table. If the table is not parallel with the wear plate, you can
loosen the table side mounting screws (3 on each side) to get the table parallel and then retighten
the screws. Repeat this procedure for the outfeed table.