Wahuda 50200PC-WHD, Руководство пользователя

Страница: 15 / 41

15
ADJUSTMENTS (cont)
Next, using the metal straight edge in the same 2 locations as above, check to see if the table is
coplanar with the wear plate. It should be one continuous flat surface from the outside edge of the
table going across the wear plate. If an adjustment is necessary, raise the table, then loosen the
lock nuts and adjust the hex head screws under each side of the table until the infeed table is
coplanar with the wear plate. A 10mm wrench or small adjustable wrench is required but not
included. Clockwise will raise the table and counterclockwise will lower the table. This adjustment
will raise or lower (slightly tilt) the outer leading edge of the table, whichever is needed. Once
coplanar, tighten the lock nuts. See picture below
Recheck to make sure the infeed table is coplanar and parallel to the wear plate and make any
necessary re-adjustments. Repeat this process for leveling the outfeed table.