Wahuda 50200PC-WHD, Руководство пользователя

Страница: 22 / 41

22
OPERATIONS (cont)
REPEAT CUT PRESET
The Repeat Cut turret style dial indicator, located on the bottom right hand side of the planer,
provides a simple way to preset the finished thickness of a workpiece. With the machine powered
off, turn the dial indicator to the desired finished thickness. Use this feature when thickness
planing multiple workpieces to ensure a uniform thickness of all workpieces. When lowering the
head assembly, ensure the Repeat Cut preset is in the lowest desired thickness position. Failure
to do so may result in excess downward pressure by the cutterhead assembly onto the
mechanism and cause damage to the adjustment rod and upper frame.
THICKNESS SCALE ADJUSTMENT
The thickness scale, located on the front right of the planer, shows the thickness of the finished
workpiece. To make sure the scale is set properly, run a piece of wood through the planer and
measure the thickness of the wood. If the scale is out of alignment, loosen the two round head
mounting screws while holding the scale indicator and adjust the thickness indicator to the
correct setting. Make sure to re-tighten the two screws once the adjustment is complete. Do not
overtighten these screws as it may damage the clear indicator.