Wahuda 50180CC-WHD, Руководство пользователя

Страница: 30 / 46

30
MAINTENANCE (cont.)
DISCONNECT THE JOINTER FROM THE POWER SOURCE!
◼
Remove any sawdust from the head of the Torx screw.
◼
Remove the Torx screw and Cutter insert.
◼ Clean all dust and dirt off the cutter insert and the cutterhead pocket from which the cutter
insert was removed, and replace the cutter insert so a fresh, sharp edge is facing outward.
Use mineral spirits or non-chlorinated brake cleaner to remove the wood residue off the
cutterhead and cutter insert before attempting to rotate them. Using a shot of compressed air
is also helpful, be sure to wear safety glasses.
Lubricate the Torx screw threads with light machine oil, wipe the excess oil off the threads, and
torque the Torx screw
to 48-50 inch/ pounds NOT FT/LBS! . When rotating a cutter insert, the
cutter insert will seat itself before tightening.
REPLACING THE BELT
WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE POWER
SOURCE BEFORE REPLACING BELT
1.
Place protective material on work surface and lay jointer on its front with rear belt cover
facing up and the open bottom facing you. Use scrap pieces to balance the jointer.
2.
Use the 4mm Hex Wrench to remove the belt guard. See FIG 29