Wahlberg Winch 25, Руководство пользователя

Страница: 31 / 44

220.805.011 31 Date: 2021-12-09
LED Functions
DMX LED
The DMX lamp will be steady green when receiving a DMX signal.
The DMX lamp will flash green if no DMX signal is present.
Error LED
The error LED will light red if there is an error.
Reset error is done by setting DMX channel 4 to 0.
When the Error LED lights red, there will also be an error description in the display.
Error and error codes:
Error Possible solution
Winch will not start,
display shows nothing. Check if the winch is connected to mains power.
Check if the fuse in the winch is intact.
Winch will not start, DMX
lamp is blinking. Check DMX signal
The wire is not wound up
on the drum correctly. Manually lower the wire totally off the drum, while controlling that
the wire comes out of the winch evenly. Afterwards the wire is rolled
back onto the drum. Reset the soft TOP limit afterwards.
Display says “Not in Pos” The winch cannot move to its position, this usually occurs when the
load is high. To solve this go into the menu and increase the Minimum
speed up.
Display says “NO
MOVEMENT D ETECTED”
The Roll Down does continuously not measure any movement when
trying to move. To solve this, check that the curtain has not caught
onto something. If not then go into the menu and increase the
Minimum speed up.
Power failure The winch will stop at power failure. When the power is re-
established, the winch has to be reset before it is ready to use.
It is advisable to set all the DMX channels on 0% before the power is
re-established.
When an error occurs, the control system shuts down the connected motor and issues a
corresponding error code. This can be queried, and used to determine the cause of the error.