Wahlberg Winch 25, Руководство пользователя

Страница: 25 / 44

220.805.011 25 Date: 2021-12-09
POS OUT Position feedback
This feature enables you to know exactly where the winch is. The position feedback outputs a DMX signal on pin
1,4,5 of the DMX in/out plugs. All values are zero except for the feedback which is located at the DMX address of
the device. Meaning if the winch has starting channel 73 then the 16bit feedback will be at channel 73 and 74.
The menu options are
- OFF: No output
- SCALE: 16 bit scaled feedback. The feedback will be 0,0 at the bottom and 255,255 at the top
- DIV 4: 16 bit raw feedback divided by 4. The feedback will be 0,0 at the bottom and TAC RANGE divided by
4 at the top. For a 10 meter span this is roughly 77,104.
- 32BIT: 32 bit raw feedback. This feedback will be 0,0,0,0 at the bottom and TAC RANGE at the top. For a 10
meter span this is roughly 0,1,53,161.
UNSAFE MODE Disable all limit switches
CAUTION!: UNSAFE MODE should only be used in emergency situations. It disables both limit switches, slack, and
emergency stop. Turning this on also makes the error LED blink.
NOM. FREQ Power input frequency 50/60
Frequency of the national grid of installation.
REVERSE DIR Reverse direction of up and down OFF/ON
Reverse motor movement, encoder, and limit switch direction.
QUICK SLACK Stop quickly when slack activates OFF/ON
Stops the winch quickly if slack is enabled. If the load is light or fast accelerations are used slack may be activated
by accident leading to a stuttering movement.
PRECISION Tolerance for settling 5 – 100
The tolerance in which the winch will stop. To small a precision will lead to the winch overshooting its wanted
position and never stop. This will cause the motor to overheat and eventually get damaged.
SLS DIST Kilometres moved Since Last Service
Shows how many kilometres the winch has travelled Since Last Service reset (SLS RESET).
SLS TIME Hours moving Since Last Service
Shows how many hours the winch has been moving Since Last Service reset (SLS RESET).
SLS ON Hours powered on Since Last Service
Shows how many hours the winch has been powered on Since Last Service reset (SLS RESET).
SLS RESET Reset Since Last Service parameters NO/YES
Set all SLS values to zero. Go through all service steps described in the manual and contact Wahlberg Motion
Design for any spare parts.
TOT DIST Kilometres moved in total
Shows how many kilometres the winch has travelled since production.
TOT TIME Hours moving in total
Shows how many hours the winch has been moving since production.
TOT ON Hours on in total
Shows how many hours the winch has been powered on since production.
FACTORY RST Reset to factory default settings NO/YES
Reset all menu values to its default settings.