352-353.805.006
11
Date: 2019-07-02
Track assembly instructions
A typical installation of the track starts from one end and then extend the track as explained from
step 1 to 5. Make sure to leave enough space to roll-on the Track Runner one of the ends, or after
securing the first track firmly to a structure.
Depending on the total weight of all the equipment hanging in the track at one point, the minimum
distance [
d
] between each securement [
C
] shall be as shown in the table below with a safety factor of
five.
Distance vs. load
d at 1m (3.3 ft) centres
d at 2m (6.6 ft) centres
D at 3m (9.9 ft) centres
Maximum point load
on track
535kg (1179 lb)
265kg (584 lb)
170kg (374 lb)
Example: Max. units
(w/o passive runner)
Max. 3 units with full load
of 50kg (110 lb) per meter
Max. 4 units with full
load of 50kg (110 lb) per
track installation
Max. 2 units with full load
of 50kg (110 lb) per track
installation
Table 1 Minimum distance between securement (brackets).
The above limitations must be followed and calculated for each customized installation, like for other
safety factors or when using a passive runner with heavy loads. Consult your Wahlberg distributor or
Wahlberg Motion Design for any questions.
A2
B
C
E
I
WARNING! Always
secure track within
specified range
d
E
A1
WARNING! Always
use the tool to align
the gear across tracks
joints
STEP
1
.
Secure the brackets
[
C
] on the first track [
A1
] from
one side of the track and
secure it firmly to the
structure (truss or pipe), see
table 1 for minimum distance
STEP
2
.
Secure the
brackets [
C
] on the second
track [
A2
] and secure it
just lightly to the structure
and the connection
bracket [
B
]. Also connect
the TRUE1 power link.
STEP
3
.
Use the tool [
I
] to
align the rack gear across
the track joints and tighten
the four screws on the
connection bracket [
B
]
before removing the tool.
STEP
4
.
Finally, firmly secure the
brackets [
C
] on the track [
A2
] to
the structure and continue from
step 2 for adding additional tracks
or apply the end covers [
D
] and
stop [
E
] when the Track Runner is
mounted, see page 14 for details.
STEP
5
.
For mounting the
equipment on the Track
Runner see page 15.
TRUE1
Power link
d
d/2
WARNING! Each piece
of track must be
secured with minimum
2 brackets
D
Содержание 352.701
Страница 27: ...352 353 805 006 27 Date 2019 07 02 Appendix 3 Power Connectors...
Страница 28: ...352 353 805 006 28 Date 2019 07 02...
Страница 30: ...352 353 805 006 30 Date 2019 07 02 This page is intentionally left blank...
Страница 31: ...352 353 805 006 31 Date 2019 07 02 This page is intentionally left blank...
