289.805.003
2
Date: 2018-11-28
Safety Information
The following symbols are used to identify important safety information on the product an in this
manual:
This product is for professional use only. It is not for household use.
This product presents risks for sever injury or death due to fire hazards, electric shock, and falls.
Read this manual before installing, powering or servicing the Mini Roll Down; follow the safety
precautions listed below and observe all warnings in this manual and printed on the Mini Roll
Down. If you have questions about how to operate the Mini Roll Down safely, please contact you
Wahlberg Motion Design supplier or Wahlberg Motion Design.
PROTECTION FROM ELECTRIC SHOCK
−
Disconnect the Mini Roll Down from AC power before removing or installing any cover or
part and not when in use.
−
Always ground (earth) the Mini Roll Down electrically.
−
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
−
Before using the Mini Roll Down, check that all power distribution equipment and cables
are in perfect condition and rated for the current requirements of all connected devices.
−
Power input throughput cables must be rated 20 A minimum, have three conductors 1.5
mm
2
(AWG16) minimum conductor size and an outer cable diameter of 6-16 mm (0.24-
0.47 inch). Cables must be heat-resistant to 90°C (194°F) minimum. In the EU the cables
must be <HAR> approved or equivalent and in the USA minimum hard usage type (SJT or
equivalent).
−
Use only Neutrik powerCON TRUE1 NAC3FX-W cable connectors to connect to power
input sockets. Use only Neutrik powerCON TRUE1 NAC3FX-W cable connectors to connect
to power throughput sockets.
−
Assembly power supply cables following the instructions in this manual only (see page 10).
−
Isolate the Mini Roll Down from power immediately if any seal, cover, cable, or other
component is damaged, defective, deformed, wet, or showing signs of overheating. Do
not reapply power until repairs have been completed.
−
Do not expose the Mini Roll Down to rain or moisture.
−
Refer any service operation not described in this manual to a qualified technician.
