289.805.003
10
Date: 2018-11-28
AC power
WARNING
! Read “Safety Information” on page
2 before connecting the Mini Roll Down to AC
mains power.
WARNING! For protection from electric shock, the Mini Roll Down must be grounded (earthed).
The power distribution circuit must be equipped with a fuse or circuit breaker and ground-fault
(earth-fault) protection.
WARNING! Socket outlets or external power switches used to supply the Mini Roll Down with
power must be located near the Mini Roll Down and easily accessible so that the Mini Roll Down
can easily be disconnected from power.
Voltage
WARNING! Check that the voltage range specified on the Mini Roll Down
’s serial number label
matches the local AC mains power voltage before applying power to the Mini Roll Down. Do
not apply AC mains power to the Mini Roll Down at any other voltage than that specified on the
Mini Roll Down’s
serial number label.
Power cables and power plug
The Mini Roll Down requires a power input cable with a Neutrik powerCON TRUE1 NAC3FX-W
cable connector for AC mains power input. The cable must meet the requirements listed under
“Protection from electric shock” on page
If you install a power plug on the power cable, install a grounding-type (earthed) plug that is rated
20 A for USA and 16A for Europe.
Follow the plug manufacturer’s instructions. Table 1 shows
standard wire color-coding schemes and some possible pin identification schemes; if pins are not
clearly identified, or if you have any doubts about proper installation, consult a qualified
electrician.
Table 1 - Colour guide
Wire Colour
Conductor
Symbol
Screw (US)
Brown
Live
L
Yellow or brass
Blue
Neutral
N
Silver
Yellow/green
Ground (earth)
or
Green
Installing a power input connector on a power cable
To install a Neutrik powerCON TRUE1 NAC3FX-W input connector on a power cable, follow the
original Neutrik instructions in Appendix 2 on page 21.
By supplying power to the Mini Roll Down, the DMX and Mode LED should light up or start flashing
depending on the situation, see page 12 for setup.
