Wahl DST400, Руководство пользователя

Страница: 5 / 25

Wahl DSTCAL Software User Manual
5
2. DSTCAL KIT INSTALLATION AND SETUP
2.1. Kit Contents
The DSTCAL Kit is delivered with a CD-ROM that includes the following files:

Application files

Autorun.inf

DSTCAL.application

Setup.exe

WD1035
– DSTCAL Load Instructions

WD1037
– DSTCAL User Manual
The DSTCAL kit also includes:

P/N Description

12436-07 Cable, USB2.0A to Mini-B, 5 pin, 6 Ft.

13506 DST/USB Interface Module

13507 Cable, DST/13506 Interface, 4 pin
2.2. DSTCAL Software Installation
1. Install DSTCAL CD-
ROM into the computers CD drive and the “AutoPlay”
window should pop up.
2.
Click on “Run setup.exe”
3. Follow the on-screen prompts.
2.3. Hardware Installation
1. Connect the 12436-
07 cable, with the USB2.0A end to your PC’s USB port
and the Mini-B connector to the USB port on the DST/USB Interface
Module.
2. Connect the 4 pin cable assembly, p/n 13507, to the DST/USB Interface
Module port labeled “DIGI-STEM”.
3. With the Digi-Stem unit open, connect the opposite end of the 13507 cable
to J3 on the back of the PCB assembly with the RED wire going to Pin 1.
Pin 1 is marked on the PCB and is the pin closest to the blue jumper for
the °C/°F switch.
2.4. Driver Installation
Once the software is loaded and the hardware is connected, your computer may
report that it needs a driver for the interface box. Usually, the automatic driver
search window will find it. If not, you can manually load the driver by:
1. Open your web browser and go to www.ftdichip.com
2.
On the left hand menu, click on “Drivers”, and then click on the sub menu
of “VCP Drivers”.
3.
Scroll down to the table labeled “Currently supported VCP Drivers:”
4.
Find your operating system, such as “Windows – X86 (32-bit) and click on
the version in the table, ie. 2.08.28.
5. Follow the auto install wizard.
6. Close the web browser.