WAGO Edge Computer
Mounting 33
752-9800
Manual
Version 1.0.0
6
Mounting
Avoid electrostatic discharge!
The devices are equipped with electronic components that may be destroyed by
electrostatic discharge when touched. Please observe the safety precautions
against electrostatic discharge per IEC 61340-5-1/-3. When handling the devices,
please ensure that environmental factors (personnel, work space and packaging)
are properly grounded.
Avoid exposure to direct light!
Position the product to avoid direct exposure to a strong light source, e.g.,
sunlight!
6.1
Assembly Guidelines/Standards
•
DIN 60204
Electrical equipment of machines
•
DIN EN 50178 Electronic equipment for use in power installations
(replacement for VDE 0160)
•
EN 60439
Low-voltage switchgear and controlgear assemblies
6.2
Mounting position
Nominal mounting position: Front, marking legible.
Device must not be operated without air gap. If adjacent device is equivalent
under full load the air gap has to be at least 12 mm. If adjacent device does not
generate heat the air gap has to be at least 6 mm.
6.3
Mount to the Rail
Mount the product by snapping it into the rail according to EN 60715:
1.
Place the product with its rail guide on the top edge of the rail.
2.
Press the product onto the rail while simultaneously pulling on the latch
until it locks into place.
3.
To ensure secure fastening on the rail, fit end clips on either side of the
device (e.g., Article No. 249-197).
