28
Connect Devices
WAGO-I/O-SYSTEM 750
750-1418 8DI 24V DC 0.2ms, low-side switching, 2-conductor
Manual
Version 1.1.0
5
Connect Devices
6
Connecting a conductor to the CAGE CLAMP
®
S
The WAGO CAGE CLAMP
®
S connection is appropriate for solid, stranded and
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
®
S connection!
Only one conductor may be connected to each CAGE CLAMP
®
S connection.
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Terminate both solid and stranded or ferruled conductors by simply pushing them
in - no tool required. For all other types of conductors, CAGE CLAMP
®
S must
be opened for connection with an operating tool with a 2.5 mm blade (order no.
210-719).
1.
To open the CAGE CLAMP
®
S insert the actuating tool into the opening
above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the CAGE CLAMP
®
S simply remove the tool - the conductor is
then clamped firmly in place.
Figure 10: Connecting a conductor to a CAGE CLAMP
®
S
