WAGNER Tribo PEA-T3, Руководство по эксплуатации

Страница: 12 / 32

Working with the spray guns
12
351874
- PEA-T3
03/2008
3.2 Switching off the spray gun
0302_Ausschalten_peat.doc
The spray gun is switched off differently depending on the type of powder injector. In the
majority of cases this process is be performed by a control unit of the coating system.
Hint
On each interruption to work, the spray gun should be blown through (purged) and
powder residue removed. In this way
powder deposits and a surge the next time the
spray gun is switched on can be largely avoided.
If you want to manually switch off the spray gun and are using a powder injector that is
not
designed for automatic purging, proceed as follows:

The atomizing air must be left open so that no powder can enter the atomizing air ducts
during purging. Switch off the powder feed.

If you do not want to change the settings for the feed air and dosage air so that you can
continue to coat using the same powder pattern, pull the powder injector out of the injector
connection on the powder container. No more powder will be fed when the powder feed is
switched back on.

Switch the powder feedback on so that the spray gun is blown clear of powder.

Finally, switch the powder feed and the high-voltage generator back off and secure against
inadvertent switching on.