WAGNER Stati-Kit 2000 0292003, Руководство пользователя

Страница: 11 / 20

1
CLEAN UP
WHEN CLEANING THE ELECTROSTATIC
SYSTEM, THESE SAFETY PROCEDURES
MUST BE FOLLOWED. FAILURE TO FOL-
LOW THESE PROCEDURES MAY RESULT
IN AN EXPLOSION/FIRE.
• Turn power pack to the “OFF” position and unplug from
power source before starting to clean.
• Be certain that gun, cable, and power pack are free of all
paint spots and cleaning agent residue.
• Exhaust and fresh air introduction must be maintained
during the clean up operation.
• Keep cleaning solvents in approved safety containers
and only in minimum quantities.
• All personnel and cleaning equipment, including con-
tainer used in cleaning operation, must be grounded.
• DO NOT turn on the VM200 power pack until the
cleaning operation has been completed, all cleaning
materials have been removed from spray area, and
spray area is free of any vapors produced by the cleaning
operation.
• If defects in the equipment are found , DO NOT use until
repairs are completed.
WARNING
11
• Clean equipment immediately after use.
• NEVER IMMERSE SPRAY GUN IN ANY FLUID
AT ANY TIME.
• Flush out fluid passages with a cleaning sol-
vent compatible with the coating material be-
ing sprayed after each use.
1. Be sure the VM200 Power Pack is turned off and
unplugged from the power source.
2. Check the coating manufacturer’s recommen-
dation for a compatible cleaning solvent.
NOTE
• The fluid passages of the spray gun should be
cleaned while cleaning the fluid hose and fluid
pump, following instructions, provided with
the fluid pump.
• Clean the spray tip and air cap by removing
from spray gun, rinsing in solvent, drying and
replacing on spray gun.
CAUTION