76
SuperFinish 23 Pro Select
FR
10.5
AIDE EN CAS DE PANNES
TYPE DE LA PANNE QUOI ENCORE?
CAUSE POSSIBLE
MESURES DE DÉPANNAGE
L‘appareil
ne démarre pas.
Pas de courant.
Contrôler l‘alimentation.
Le fusible de l‘appareil a
déclenché.
Laisser refroidir le moteur.
L‘appareil
n‘aspire.
Il ne sort pas de bulles d‘air
du tuyau de retour.
Soupape d’admission ou
de sortie bloquée / usée
Démonter la soupape et la nettoyer (-> voir
les points 10.1/10.2). Remplacer les pièces
usées
Vanne de régulation de
pression entièrement
tournée en arrière.
Tournez la vanne de régulation de pression à
fond vers la droite.
Des bulles d‘air sortent
du tuyau de retour.
L‘appareil aspire de l‘air
parasite.
Contrôlez: le système d‘aspiration est-il
convenablement serré?
Organe d’admission rouge à l’entrée du pro-
duit de revêtement (-> voir point 4.1)
L‘appareil
ne génère pas
de pression.
L‘appareil a aspiré.
Air dans le circuit d‘huile.
Purgez le circuit d‘huile de l‘appareil; à cet
effet, tournez la vanne de régulation de
pression entièrement vers la gauche (jusqu‘à
l‘excès) et laissez tourner pendant env.
2-3 min, puis tournez la vanne de régulation
de pression entièrement vers la droite et
réglez la pression de pulvérisation (répétez
éventuellement plusieurs fois l‘opération).
L‘appareil est arrivé en pres-
sion, mais la pression chute
au manomètre lors de la pul-
vérisation.
Filtre d‘aspiration bouché. Contrôlez le filtre d‘aspiration/éventuelle-
ment nettoyer/remplacer.
La peinture ne peut pas
être mise en œuvre dans
cet état, la peinture colle
les vannes (vanne d‘aspi-
ration) par ses caractéris-
tiques et le débit est trop
faible.
Diluer la peinture.
L‘appareil est arrivé en
pression, mais le jet de pul-
vérisation s‘arrête lors de la
pulvérisation alors que le
manomètre affiche une pres-
sion élevée.
Des filtres bouchés
laissent passer trop peu
de peinture.
Contrôler/nettoyer le (filtre haute pression si
présent,) le filtre du pistolet.
Buse bouchée.
Nettoyer la buse.
L‘appareil ne génère pas la
pression max. possible, de
la peinture sort du tuyau de
retour malgré la position de
pulvérisation.
Vanne de décharge défec-
tueuse.
Veuillez vous adresser au service après-vente
Wagner
RÉPARATIONS SUR L'APPAREIL
Содержание Brillux SUPER FINISH 23 PRO SELECT
Страница 86: ...86 SuperFinish 23 Pro Select FR ...
Страница 87: ...87 SuperFinish 23 Pro Select FR ...