36
ProSpray 39 Select
GB
Description of unit
3.5
Technical data
Voltage:
220-240 Volt AC, 50/60 Hz
Max. current consumption:
9.5 A @ 230VAC
Power cord:
3 x 1.5 mm
2
– 6 m
Acceptance capacity:
2185 Watt
Max. operating pressure:
221 bar (22,1 MPa)
Volume flow at 12 MPa
(120 bar) with water:
5.0 l/min
Max tip size:
0.039 inch – 0.99 mm
Max. temperature of the
coating material:
43°C
Max viscosity:
30.000 MPa·s
Weight:
46 kg
Dimensions (L X W X H):
787 x 648 x 965 mm
Altitude:
This equipment will operate
correctly up to 2000 m above mean
sea level
Max sound pressure level:
80 dB (A) *
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6 Transportation
Pushing or pulling the unit
Pull out the handle (Fig. 3, Item 1) until it will come no further. Insert
the handle – push the buttons (2) on the spars, and then push in the
handle.
2
1
2
3.7
Transportation in vehicle
Secure the unit with a suitable fastening.
3.8
Textured material setup
i
This sprayer comes with a filter plug that should be
put in place of the filter whenever spraying textured
materials. Follow these steps to remove the filter
and install the plug.
1. Loosen and remove the filter housing (1) by hand.
2. Remove the adapter spring (2), filter (3), bearing ring (4) and
spring (5) from the housing (7).
3. Make sure the O-ring (6) is still in place. Thread the filter plug
(8) into the housing until secure.
i
The filter plug should be hand-tightened, but make
sure it is seated fully into the filter housing.
1
2
4
5
3
6
8
7
i
If using this sprayer with textured materials, it is
important that the filter inside of the spray gun be
removed. See section 8.4.
i
If the sprayer will be used for spraying textured
products, removal of the inlet screen in the foot
valve may be necessary. This will allow proper
priming and flow of the textured product. See
section 8.3.
Содержание Brillux PROSPRAY 39 SELECT
Страница 102: ...100 ProSpray 39 Special...
