WAFER GSM-KEY REMOTE CONTROL UNIT
http://www.waferstar.com
Acknowledge
: ALARM_IN1=ON:SMS:300, ALARM_IN2=ON:PHONE:10
If at phone mode: when receive the alarm input,then will phone the number in the alarm phone list until you
reject the phone call or that will continue to phone the number again after the minutes setted.
If at SMS mode: When receive the alarm input,then will send the SMS to the number in the alarm phone list
until you send the SMS to PAUSE the alarm .
(5) Config the SMS TEXT :
(PC)
#PWD123456#UDI1:XXXXXX, UDI2:XXXXXX
Acknowledge
: UDI1:XXXXXX, DI2:XXXXXX OKAY
(When the Alarm input is triggered,then will send the
SMS you already setted with this UDI command)
Check the text set
#PWD123456#UDI?
Acknowledge:
UDI1:ABC1, UDI2:ABC2
#REPORT Report the system status change
(PC$PHONE)
When setup to:
#PWD123456#REPORT=ON
Then any device status change would send the alarm SMS to Alarm01 number
#PWD123456#REPORT=OFF
No report for the device status change
#PWD123456#REPORT?
Check the REPORT setting status
#CSQ Check GSM signal quality
.
(PC$PHONE)
This command is useful to see what is the GSM network
signal level your GSM-KEY is receiving. It ranges from 0 to 32 (if it is 0 we doubt it will
ever answer...). You should have a signal above 12 to be sure of being able to open the
gate in any condition. Better if above 16. You should add an external antenna if this is not the case,
or eventually even change operator with another that serves your area better.
#PWD123456#CSQ?
Acknowledge:
CSQ IS 26
#MODE Relay Operation Mode SETUP
(PC$PHONE)
#PWD123456#MODE0
Acknowledge
: RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
: RELAY SET TO MODE1
If set to MODE0,that is
Momentary pulse and If Config to MODE1,that is Ratchet relay
#STATUS Check the config information of the terminal
(PC$PHONE)
#PWD123456#STATUS?
You will receive a Acknowledge with:
ALARM1=ON:SMS:040960,ALARM2=OFF:SMS:4352,GOT=05S,WHL=01,ALARM1=HIGH,
ALARM2=HIGH,BCPW=00,CSQ=10,RELAY1=ON,RELAY2=OFF
