WAFER GSM-KEY REMOTE CONTROL UNIT
http://www.waferstar.com
#OUT Control the Relay Output on or off
(PC$PHONE)
#PWD123456#OUT1=ON or OFF
#PWD123456#OUT2=ON or OFF
(If has the second relay output on board)
Config the RELAY Status when power Reset again
#PWD123456#POWER-RESET=11 (1 means ON ,0 means OFF when power on)
You will receive the following similar confirmation from the unit
POWER-RESET OK
#PWD123456#POWER-SAVE
You will receive the following similar confirmation from the unit
POWER-SAVE OK
Customized output control command TEXT:
(PC$PHONE)
#REPLY SMS reply OFF or ON
#PWD123456#REPLY=ON
When setup to ON,then Device will reply the customized command after Relay is toggled
#PWD123456#REPLY=OFF
When setup to OFF,then Device will not reply the customized command after Relay is toggled
(This command is used to save the cost for user)
With these command you can customize the command to control your output.then would be easy
for you to understand the command
#PWD123456#OPEN1-TEXT#XXXX
#PWD123456#CLOSE1-TEXT#XXXX
#PWD123456#RLY-TEXT1#XXXX
If have the second output reply,then use the following command to config the second output
#PWD123456#OPEN2-TEXT#XXXX
#PWD123456#CLOSE2-TEXT#XXXX
#PWD123456#RLY-TEXT2#XXX
Check the Customized command text:
#PWD123456#OUT1-TEXT?
Reply:
OPEN1-TEXT=OPEN1,CLOSE1-TEXT=CLOSE1,TRIG1-TEXT=XXXX
#PWD123456#OUT2-TEXT?
Reply:
OPEN2-TEXT=OPEN2,CLOSE2-TEXT=CLOSE2,TRIG2-TEXT=XXXX
For example,you send the command:
#PWD123456#OPEN1-TEXT#GATE1 OPEN
Then you can use the simple SMS: GATE1 OPEN to switch on the output1 relay
#PWD123456#CLOSE1-TEXT#GATE1 CLOSE
Then you can use the simple SMS: GATE1 CLOSE to switch off the output1 relay
#PWD123456#RLY-TEXT1#GATE1 DIAN
Then you can use the simple SMS: GATE1 DIAN=5 to trigger the output1 relay for 5 second
