Waeco PerfectView M170L, Инструкция по установке и эксплуатации

Страница: 28 / 148

Safety and installation instructions
PerfectView M170L
28
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
z The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
z
Secure the monitor in such a way that it cannot become loose under any circumstances
(sudden braking, accidents) and cause
injuries to the occupants of the vehicle.
z Do not attach the monitor in the air bag deployment path, as this could cause injury if
the airbags are triggered.
z To prevent damage, when drilling ensure that there is sufficient space on the other side
for the drill head to come out (fig.
2 , page 4).
z Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
z When testing the voltage in electrical cables, only use a diode test lamp
(fig.
1 1, page 3) or a voltmeter (fig. 1 2, page 3).
Test lamps with an illuminant (fig. 1 3, page 3) consume voltages which are too high
and which can damage the vehicle’s electronic system.
z When making electrical connections (fig. 3 , page 4), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection
z Insulate all connections.
z
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
Observe the following instructions when handling the LCD monitor:
z
Do not open the monitor (fig.
4
, page 4).
z Do not submerge the monitor in water (fig. 5 , page 4); the monitor is not waterproof.
z The monitor must not impair your vision when driving (fig. b , page 7).
z Do not use the monitor when you are driving.
z Do not operate the monitor with wet hands.
z
Do not operate the monitor if the housing has been damaged.
z Connect it to the correct voltage.
_M170L.book Seite 28 Mittwoch, 9. Juli 2008 2:50 14