MagicWatch MW650
Installing MagicWatch
35
6
Installing MagicWatch
6.1
Tools required
For
installation and assembly
you require the following tools:
z
Drill bit set (see fig. 1.1, page 3)
z
Drill (see fig. 1.2, page 3)
z
Screwdriver (see fig. 1.3, page 3)
z
Set of ring or open-ended spanners (see fig. 1.4, page 3)
For making and testing the
electrical connection
the following tools are
required:
z
Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)
z
Crimping tool (see fig. 1.7, page 3)
z
Insulating tape (see fig. 1.8, page 3)
z
Cable bushing sleeves, if required
To
secure the controller and the cable
you may require additional screws
and cable binders.
6.2
Fitting the sensors
The sensors must be correctly aligned for the device to work.
If these point to the ground, bumps in the ground may be inter-
preted as obstacles. If they point too far up, obstacles will not be
detected.
Note the following information during installation:
z
The maximum range is around 2,5 m for the visual display and 1.5 m for
the audible display.
z
So that the corners of the vehicle (indicator lights etc.) can be monitored,
the sensor should not be fitted more than 0.3 m away from them.
z
The sensor may only be fitted under the bumper (see fig. 12, page 6). If it
is fitted upside-down, it will detect the ground.
MW-650-4DSM.book Seite 35 Dienstag, 16. Mai 2006 4:28 16
Содержание MagicWatch MW650
Страница 3: ...MagicWatch MW650 3 1 2 3 4 9 6 8 5 7 1 MW 650 4DSM book Seite 3 Dienstag 16 Mai 2006 4 28 16...
Страница 4: ...MagicWatch MW650 4 4 1 3 5 6 2 4 2 3 MW 650 4DSM book Seite 4 Dienstag 16 Mai 2006 4 28 16...
Страница 7: ...MagicWatch MW650 7 14 A B B B B 15 A B 16 MW 650 4DSM book Seite 7 Dienstag 16 Mai 2006 4 28 16...
Страница 8: ...MagicWatch MW650 8 2 3 31 1 17 MW 650 4DSM book Seite 8 Dienstag 16 Mai 2006 4 28 16...
