Installing MagicWatch
MagicWatch MW650
36
z
The distance from the sensors to the ground must be between 40 cm and
50 cm (see fig. 10, page 6).
z
The horizontal alignment of the sensors must be 0° (see fig. 10, page 6).
z
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee the optimum monitoring.
The assembly procedure is as follows:
➤
Select a fitting position under the bumper which is as parallel as possible
to the road surface (see fig. 12, page 6).
➤
Place the rubber plate (see fig. 4.6, page 4) between the sensor and the
bumper.
➤
Screw the sensors to the bumper using the nuts and bolts supplied.
6.3
Laying the sensor extension cables
When laying cables, ensure that:
z
They are not kinked or twisted
z
They do not rub on edges
z
They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
z
The plugs must be connected with the correct polarity. A blocking pin pre-
vents reverse polarity (see fig. 13 A, page 6).
z
Make sure the locking pin catches (see fig. 13 A, page 6). Only then is
trouble-free operation guaranteed.
To
release the connection
press the holder and pull the plug and socket
apart (see fig. 13 B, page 6).
z
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCS-1) as accessories.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics to
ensure that the display is correct.
MW-650-4DSM.book Seite 36 Dienstag, 16. Mai 2006 4:28 16
Содержание MagicWatch MW650
Страница 3: ...MagicWatch MW650 3 1 2 3 4 9 6 8 5 7 1 MW 650 4DSM book Seite 3 Dienstag 16 Mai 2006 4 28 16...
Страница 4: ...MagicWatch MW650 4 4 1 3 5 6 2 4 2 3 MW 650 4DSM book Seite 4 Dienstag 16 Mai 2006 4 28 16...
Страница 7: ...MagicWatch MW650 7 14 A B B B B 15 A B 16 MW 650 4DSM book Seite 7 Dienstag 16 Mai 2006 4 28 16...
Страница 8: ...MagicWatch MW650 8 2 3 31 1 17 MW 650 4DSM book Seite 8 Dienstag 16 Mai 2006 4 28 16...
