Waeco MagicSafe MS650, Инструкция по установке и эксплуатации, Страница: 60 / 274

Programming
60
Turn on the ignition.
1. Enter the first digit of *PIN code using the access switch
Turn the ignition off and on.
2. Enter the first digit of *PIN code using the access switch
Turn the ignition off and on.
Press blue button on hand transmitter.
Turn the ignition off and on.
Software switch selection
Press the access switch once
to change to
1-1 Self-activating
1-2 Alarm duration
1-3 Locking of the central locking
with reactivating
1-4 Locking/unlocking via the
ignition
1-5 Siren tone ON/OFF
1-6 Duration of impulse of the
door switch activation
Press the access switch two
times to change to:
2-1 Convenience output active
2-2 Duration of impulse
convenience output
2-3 Self-activation with
delay time.
2-4 Delay time for
alarm triggering
2-5 Siren / horn selection
2-6 Reactivate
Press the access switch three
times to change to:
3-1 *PIN-access code
3-2 Delete all hand transmitters
3-3 Reset all software functions to
the basic setting
Turn the ignition off and on.
Now press the service switch until the value of the second digit of the desired software function is
the desired number.
To switch on the function (ON), press the blue button of the hand transmitter.
To switch off the function (0FF), press the grey button of the hand transmitter.
The status (ON /0FF) is displayed via the LED. Switch = ON => LED is on, Switch = OFF => LED is off
Turn the ignition off.
Press the access switch
or wait approx. 15 sec. Exit mode confirmed by double-tone
from siren.
Turn the ignition on.
MS-650.qxd 13/08/03 12:58 Page 60