Waeco CoolAir SP950T, Руководство по установке

Страница: 34 / 284

EN
Installation CoolAir SP950T
34
7.2.6 Installing supply lines to the condenser unit
Observe the following instructions when installing the supply lines:
 Also observe the installation instructions for the condenser unit.
 The maximum cable length between the evaporator and condenser
unit is 4.20 m (fig.
5 , page 4).
 When installing and bending supply lines, avoid narrow radii. Use a
suitable round object as a bending aid. A radius which is too narrow
will buckle the refrigerant line, and the parking cooler will be inoper-
able.
➤
Shorten any supply line which is not needed by bending a curve.
➤
Apply packing compound (fig. 6 1, page 4) to prevent water entering
between the rear wall of the truck and the clip.
I
➤ Fasten the supply lines to the rear wall of the truck using the clips
provided (fig.
6 , page 4).
➤
Insert the corrugated piping in the holder provided (fig. 6 2, page 4).
➤ Put the cover on (fig.
6
4, page 4).
7.2.7 Fastening the cover frame
A
➤
Fasten the cover frame (fig. 7 8, page 5) to the unit with the four
cylindrical screws (fig. 7 10, page 5), washers (fig. 7 9, page 5)
and the eight spacer sleeves (L = 40 mm,
∅
10 mm: fig. 7 6, page 5;
L = 48 mm,
∅
10 mm: fig. 7 7, page 5). The spacer sleeves keep the
cover frame apart from the unit.
NOTE
If you wish to avoid damaging the rear wall of the truck (drilling a hole),
you can also apply the clip using a suitable adhesive. Observe the
instructions provided by the adhesive manufacturer.
NOTICE!
Screw the screws in carefully order not to damage the cover frame.