Wacom Inkling MDP-123, Руководство пользователя

Страница: 17 / 48

17
Index Contents
17
Index Contents
ATTACHING THE RECEIVER TO PAPER
A new sketch file is created whenever the receiver clip is opened and then closed as you attach the Inkling
receiver to a sheet of paper. Attach the receiver to loose sheets, or to pages in a notebook or drawing pad.
The receiver can accept up to 10 pages (1 mm or 0.04 inch total thickness) at a time.
The Inkling default condition is for placement of the receiver at the top center of an A4/letter sized page in
portrait orientation. However, you can orient the receiver on any side of the paper, depending on your
preferred handedness or sketching style. See
managing Inkling settings for details.
1. Squeeze the receiver clip
slightly and insert paper into
the opening. Release the
clip. Be sure to center the
receiver on the page edge.
2. Press the receiver power
button. Wait until the power
LED stops blinking and
glows green.
3. Begin sketching .
Tips:
• After you attach the receiver, leave it in place until you are done sketching. If you remove and then replace the
receiver, the new pen strokes you make on paper will be mis-aligned with the previous strokes when recorded in
digital form.
• When you change pages and the receiver is on, the new layer LED lights momentarily to indicate the creation of
a new sketch file.
Receiver
There is a limited performance zone below the
receiver. Within this narrow zone the receiver
cannot reliably record your pen strokes.
Always write or sketch below this zone.
The limited performance zone is approximately
2.0 cm (0.8 inch) on A4/letter size paper. It may
vary slightly for larger or smaller paper sizes.
Paper