Wacker Neuson MFS735-CE, Руководство оператора, Страница: 23 / 44

23
MFS735 Operation
4.8 Use of the Cutting Blade
Things to
Remember
General application instructions for use of diamond cutting blades:
1. Never use a diamond cutting blade of a diameter larger than necessary to cut
down to a certain depth.
2. Pull the blade out of the cut if it has stopped turning and before restarting the
engine. Check to see if the belt has been tensioned sufficient if the cutting blade
should get stuck in the cut. Also check the tensioning screw and make sure that
it is correctly tightened.
3. Always cut a straight line. Mark the line clearly allowing the operator to follow it
easily without having to guide it from one side to the other to come back to the
line (do not cut narrow curves).
4. Sufficient drive power is essential, therefore always cut with engine at full
throttle.
5. Never exceed the maximum turning speed (printed on cutting blade).
6. Only use appropriate cutting blade for the material you are going to cut. Wacker
Neuson has an extensive selection of diamond blades in different grades of
qualities for you.
Diamond blades for asphalt are suited for:
Types of
Asphalt
„
Asphalt
„
Freshly mixed concrete (from 48 hours to 28 days old)
„
Sandstone
„
Sandy bricks
„
Floor toppings
„
Sandy limestone
Not suited for
„
Set concrete
„
Hard bricks or paving setts
„
Concrete with exposed aggregates by washing
„
Natural stone
Diamond blades for concrete are suited for:
Type of
Concrete
„
Set concrete (older than 28 days with reinforcements up to maximum diameter
of 6mm)
Not suited for
„
Other kind of materials