wc_tx003097gb.fm
27
LTN 6L-V
Operation
4.5
Aiming the Lights - LTN-V
Overview
Each individual light fixture can be aimed up, down, left, or right independent of
one another. There are four total light fixtures on each machine.
The light bars, which include two light fixtures each, can be tilted 45° in each
direction from horizontal.
This procedure is not for rotating the lights as a single unit while the tower is
raised. This procedure requires the tower is lowered and the is machine
stopped. To rotate the lights, see topic
Rotating the Lights
.
Requirements
Before adjusting the lights, make sure that the following conditions have been met.
Machine is stopped
Tower is completely lowered
Lights are cool to the touch
Aiming the
light fixtures
Aiming Up or Down
Perform the procedure below to aim an individual light fixture up or down.
1. Loosen the T-handle
(a)
and aim the light up or down.
NOTICE:
Do not loosen the nut
(b).
Damage to the light fixture may occur.
2. Tighten the T-handle
(a)
when the light is aimed properly.
3. Repeat steps 1—3 for each remaining light fixture, if desired.
This procedure continues on the next page.
wc_gr009317
a
a
a
b
