Wacker Neuson DW100, Руководство оператора

Страница: 133 / 228

BA D18 us* 1.1 * D18b510.fm
5-33
Operation 5
Putting back into operation
Information
If the machine was out of operation over a longer period of time without
performing the specified steps, contact a Wacker Neuson service center
before putting back into operation.
1. Perform a general visual check of the damage on the electric cables,
connectors, fuel lines, corrosion, etc. on the engine and particulate
matter catalyst.
2. Start the engine once a month to ensure optimal lubrication.
3. Remove anticorrosion agents from bare metal parts.
4. Charge, install and connect the battery.
5. Open the air-intake openings of the air filter system and exhaust pipe.
6. Check the condition of the air filter elements and have them replaced
by a Wacker Neuson service center if necessary.
7. Bleed the fuel system – see chapter “ Bleeding the fuel system” on
page 7-22 .
8. Check the machine for leaks.
9. Lubricate the machine according to the lubrication plan.
10.Check all engine/machine fluids in the units or reservoirs, and add
fluids if necessary.
11.If the machine was out of service for over six months, change the oil in
the gearbox, engine, hydraulic oil reservoir and other units.
12.Have the hydraulic oil filters (return and breather filters) replaced by a
Wacker Neuson service center if the machine was out of operation for
over six months.
13.Switch on the starter and check whether there are any malfunctions –
see chapter “8.1 Engine warning lights” on page 8-1 . In case of
malfunctions, contact a Wacker Neuson service center and have the
malfunction rectified.
14.Start the engine.
15.Let the engine run at idling speed at least 15 minutes without load.
16.Stop the engine.
17.Check the oil levels in all units and add oil if necessary.
18.Check the machine for leaks.
19.Start the machine and ensure that all functions and warning systems
work correctly.
Avoid operation at maximum engine speed or load for an hour.