WACKER Group 0007587, Руководство по ремонту

Страница: 19 / 44

TROWEL REPAIR GUIDE HANDLE 2
2-9
1001RM14
1001RM15
1001RM16
t
u
v
w
x
y z aa bb
Assembly:
1. Place
Pro-Shift ®
housing in a vise. Make sure that the
two washers
(t)
, wave spring
(u)
, and serrated plate
(v)
are positioned properly over each pivot tube.
2. Slide control cable over dowel pin. Slide dowel pin
back into position through handle legs
(x)
. If so
equipped, install retaining washer.
3. Using pliers, squeeze handle legs
(x)
together and
slip handle into place on the pivot tubes. Make sure
that the handle is seated properly.
4. Using C-clamps, evenly compress the wave springs
against the housing until the holes in the handle are
flush with the pivot tubes
(w)
.
5. Slide torsional spring
(z)
over mandrel
(y)
and insert
assembly between pivot tubes.
6. Insert threaded rod
(aa)
and secure with nuts
(bb)
.
On some machines this rod may be replaced with
a bolt.