WACKER Group 0007587, Руководство по ремонту

Страница: 10 / 44

1-6
1 INTRODUCTION TROWEL REPAIR
1.7 Application
The CT series of trowels are modern, high production
machines intended for floating and finishing freshly poured
concrete slabs. The machine’s good balance, adjustable
handle, and easily accessible controls add to operator
comfort and productivity. An automatic stop switch, or a
combination of an automatic stop switch and an operator
present lever, provide added operator safety. Finishing
rates will depend on operator skill and job conditions.
1.8 General Description
For the CT product line of trowels, engine power is
transferred through a centrifugal clutch and V-belt to the
gearcase and down to the trowel blades. The four trowel
blades are mounted on a spider assembly mounted on the
gearcase output shaft. The spider assembly adjusts the
trowel angle by being raised by the yoke-trowel blade lift.
The trowels can be tilted from 0° - 15 °. The speed
of the trowels ranges from 60-165 rpm, depending on
the model.
1.9 Periodic Maintenance Schedule
The chart below lists basic trowel maintenance. Refer to engine manufacturer’s Operator’s Manual for information on
engine maintenance. A copy of the engine Operator’s Manual was supplied with the machine when it was shipped.
Daily After After Every two Every Every two
before each first weeks or month or years or
starting use 5 hours 50 hrs. 100 hrs. 750 hrs.
Check and tighten external hardware.
●
Grease trowel arms.
●
Check and adjust drive belt.
● ●
Grease adjusting yoke.
●
Change gearcase oil.
●
Inspect pitch cable.
●
Change trowel gearcase lubricant.
●
1.10 Symbols
Symbols Used on Repair Pages
L1 Indicates a sealant or threadlocking compound to
be used when assembling part.
[L1] Refer to Sealant Chart at end of manual for
description of sealants.
T1 Indicates the correct torque value for
assembling part.
[T1] Refer to Torque Chart at end of manual for
standard torque measurements.