WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
2
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION
STEP 1:
1.
Make sure your main power is off.
2.
At the point of installation, mount the stake by placing
a piece of wood on the stake and hammering the wood.
Hammer till the bottom of the ring is flush with the ground.
3.
In the case of hard soil, dig a hole and place the stake in
so that the bottom of the ring is flush with the ground.
Fill the rest of the hole with the removed soil and pack it
tight to secure the stake.
4.
Screw the fixture onto the stake provided, leading the wire
from the fixture through the wire slot in the stake.
STEP 2:
5. Cut the power supply wire from the transformer at the
location of the fixture.
6. Separate the power supply wire into two individual wires
by lightly pulling on each side so that a couple inches is
separated.
7. Strip off ½ inch of the insulating material from each wire and
connect one to each of the wires from the fixture using the
outdoor rated direct burial wire nuts provided.
STEP 3:
8. Screw the fixture onto the stake provided, leading the wire
from the fixture through the wire slot in the stake.
9. If desired, bury your wire by digging a small trench. Close the
trench by applying an inward force to both sides of the trench.
10. Repeat steps for other fixtures in the same electrical circuit.
11. Turn the main power supply back on and make sure the
fixtures light up.
Hammer
Wood
Mounting Stake
Soil
Soil
Transformer
Transformer
To Next Fixture
Mounting Stake
Mounting Stake
Fixture Wires
Supply Wire between Fixtures
Wire Slot
Path Lighting
Fixture
Path LightingFixture
Note:
To install multiple fixtures, also connect the power supply wire of each
additional fixture to the connection described in 7 of the previous fixture.
INSTALLATION INSTRUCTION
PATH LIGHT
6011 / 6021 / 6031 / 6041 / 6051 / 6061 / 6071 / 6081 / 6091 / 6321 / 6311
