WABECO CC-F1410 LF hs, Руководство по эксплуатации

Страница: 44 / 159

44
10. Feed motions of the X-, Y- and Z-axes
■ The longitudinal motion of the cross slide support (X-axis) is carried out by turning the hand wheel
(7).
■ The transverse motion of the cross slide support (Y-axis) is carried out by turning the hand wheel (9).
■ The feed motion of the boring and milling depth (Z-axis) is carried out via the hand wheel (3).
There are scale rings fitted to enable you to read off the distances.
One interval on the scale represents a distance of 0.05 mm. One full turn of the hand wheel is the same
as a skid distance
■ Scale ring X-axis (6)
with trapezoidal threaded spindle of 4 mm - with ball screws of 5 mm
■ Scale ring Y-axis (8)
with trapezoidal threaded spindle of 4 mm - with ball screws of 5 mm
■ Scale ring Z-axis (2)
with trapezoidal threaded spindle of 2 mm - with ball screws of 2.5 mm
Another option for moving the tool spindle is to use the rotation motion of the activation lever (4).
■ After undoing the clamping lever (1) the rotation motion may be executed.
■ One mark on the scale ring (5) represents a distance of 1 mm.
■ Then tighten the clamping lever (1) back up again.
■ The largest distance of the tool spindle is 55 mm.
It is recommended not to select a travel distance that is too big, instead, in the event of a greater depth,
you should use multiple passes to achieve the milling machine depth needed.