WEL/ IM/ 05/ 18.03.2016
7
•
Clearance between the Module frame and the mounting surface is required to allow cooling air to
circulate around the back of the Module. This also allows any condensation or moisture to dissipate. The
Module should never be sealed to the mounting surface with sealant that prevents air from circulating
under the Module. For roof mounted systems, provide adequate rear ventilation (100mm: 4inch gap
minimum) for cooling of Modules.
•
Please contact WAAREE’S authorized representative for any questions regarding mounting profiles for
Modules.
SPECIFICATIONS
•
Please refer latest Module datasheet for Specifications.
SOLAR PV MODULE MOUNTING GUIDELINES
General Mounting Guidelines:
•
The Module should be facing true south in northern hemisphere and true north in southern hemisphere
for maximum power production.
•
We recommend leaving a space of at least 10 mm between two Modules considering linear thermal
expansion of the Module frames.
•
Since sparks may occur, do not install the Module where flammable gases or vapors are present.
•
During installation all local and national electrical and building codes and regulations shall be strictly
observed.
•
Avoid using a mounting method that will block the drainage holes in the Module frame.
•
Do not install SPV Modules in a location where they will be immersed in or continually exposed to water.
•
Site-specific loads such as wind and snow need to be taken into consideration to ensure that the
pressure of such a load does not exceed the specified maximum load.
•
Always abide by the instructions and safety precautions included with the Module. The mounting
structure and all hardware like bolts, nuts and washers should be of stainless steel so as to eliminate the
possibility of rust.
•
When installing a free standing ground mounted system, be sure to select the appropriate height of the
support Module mounting structure. It is also important to select the appropriate height of the
mounting system to prevent the lowest edge of the Module from being covered by snow for a long time
in areas that experience heavy snowfall.