43
(c) Snap the terminals into each connector housing. Use a small
flat-bladed screwdriver to push each terminal into the housing. The
terminals only insert one way and will click into place. Be sure
you’re inserting the terminals into their correct hole on the
housing, because once installed they are difficult to remove.
Important: Make sure the wires don’t cross, i.e., pin 1 on one
housing should mate with pin 1 on the other housing. Note that pin
1 is identified on the silkscreened legends.
(d) Plug one end of the cable assembly into P102 on the
main circuit board, and the other end into P302 on the front
panel circuit board. Again, be sure not to cross the wires.
One end of the prepared cable plugs into P302 on the front panel
circuit board.
(11) Identify the miniature round speaker (Mouser p/n 665-
AS04508MR3R).
(Hint: a local source of small speakers is a drugstore or
card shop that sells greeting cards that play songs. Remove the speaker,
save the battery in your junk box, and send the card to your mother-in-
law.)
Twist together two 12 inch lengths (approximately) of 22 AWG
