58
Completed enclosure with five slots, which hold a
total of ten cables (for a Yaesu FT-2000 transceiver)
(13) Mount the pod circuit board on the four posts of the enclosure using No.4 x 3/8”
sheet metal screws. Carefully route the cables through the slots in the rear of the
enclosure, using cable ties (Ty-Wraps) as strain reliefs. Then install the cover on the
enclosure, using the flathead screws provided with the enclosure. This completes the pod
assembly.
Completed pod for an FT-2000 transceiver
XI. Final Instructions
(1) You have now completed all the required modules for the StationPro II. All that
remains is for you to connect together the Controller Unit, the RF Relay Unit and the
transceiver pods, and then to connect your transceivers and linear amplifiers to the
StationPro II. Hookup information is contained in
A: StationPro II Operating
Instructions
, as well as instructions for operating the StationPro and understanding its
features. You will need to buy three 25 pin computer “serial” cables (male/female
connectors) and one standard 8-pin ethernet cable, all available from any computer or
office supply store, or Radio Shack. These cables should be as short as possible,
consistent with the layout of equipment on your operating desk. It is preferable to use a
shielded ethernet cable, if available.
