Vytronix PW1500, Инструкция по эксплуатации

Страница: 12 / 14

11
Symptom Possible cause Recommended action
Machine will not
start
Machine not plugged in Plug in machine.
Defective socket Try another socket.
Fuse has blown Replace fuse.
Defective extension cable Try without the extension cable.
Fluctuating
pressure Pump is sucking air Check that hoses and connections are
airtight.
Water supply insufficient Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Machine stops
Fuse has blown Replace fuse.
Incorrect mains voltage Check that the mains voltage corresponds
to specification on the name plate.
Thermal sensor activated Leave the machine for 5 minutes to cool
down.
Nozzle partially blocked Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.
Fuse blows
Fuse too small Change to an installation higher than the
amperage consumption of the machine.
Amperage increase Try without the extension cable.
Machine pulsating
Air in inlet hose/pump Allow machine to run with open trigger
until regular working pressure resumes.
Inadequate supply of mains
water specifications
required Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Nozzle partially blocked
Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.
Water filter blocked Clean the filter.
Hose kinked Straighten out hose.
Machine often
starts and stops by
itself
Pump and/or trigger gun is
leaking
Contact manufacturer.
No water supply Connect inlet water.
Machine starts but
no water comes
out
Water filter blocked Clean the filter.
Nozzle blocked Clean the nozzle with a needle and by
spraying water backwards through the
nozzle.
For further advice, information or assistance please contact Vytronix.
6. Trouble shooting