Vytronix PW1500, Инструкция по эксплуатации

Страница: 9 / 14

8
IMPORTANT:
Place the pressure washer on firm, level surface during operation, do
not sit the pressure washer in long grass as objects may enter the vents or openings.
Do not cover the machine during operation, use it indoors or in any area without
adequate ventilation.
IMPORTANT: Do not leave the pressure washer switched on if leaving unattended for
any length of time.
IMPORTANT: The pressure gun and lance are affected by a thrust during operation,
therefore always hold it firmly with both hands before pulling the trigger and point
the nozzle at the ground to begin with.
1.
With the pressure washer OFF, pull and hold in the trigger on the pressure gun
until water begins to flow through it, then release the trigger.
2. Turn the pressure washer on at the start/stop button, the machine will power up
for a few seconds to prime itself and will then stop. The pressure washer is now
ready to use.
NOTE: When releasing the trigger of the pressure gun, the machine automatically
stops. The machine will start again when you re-activate the trigger.
The pressure nozzle can be adjusted by tuning it.
WARNING: Do not do this while holding the trigger
in to avoid risk of the water jet hitting your hand.
Pull the trigger on the pressure gun to test the
jet, release the trigger and twist the end of jet
nozzle to adjust the type of water spray, then
pull the trigger again to test. Repeat until desired
spray is set depending on what you want to clean.
3.4 Start/stop of the machine
3.5 Multi Nozzle