41
vwr.com I Instruction manual VWR® G Water System
on the main screen will reach the top, showing 100%. When the water level is lower than 80%, the
system will automatically restart production.
Water will stop dispensing automatically if tank water level falls below 10% (tank empty). Press
dispense button to stop dispensing until the tank is refilled.
3.3.3 Degassing the System
a) Remove stopper from the UP dispenser outlet.
b) Screw on the adapter (in the accessory bag) to the dispenser outlet. Connect the PVC tubing
inside the accessory bag; insert one end to the adapter and put the other end into the drain.
c) Press the dispense button to dispense water. Gas inside the system will be released out of the
system.
d) Wait till no more gas bubbles coming out of the tubing. Press Dispense button again to stop
degassing. Screw off the adapter.
3.3.4 Installing the Final Filter
a) Open the attached final filter package.
b) Screw the final filter onto the remote dispenser until finger-tight (no leaking at dispensing). Do
not over tighten it as it may damage threads.
c) Press the dispense button to flush out gas in the filter.
d) Press the dispense button again to stop dispensing.
3.3.5 Tank Recirculation Setup (Optional)
Swipe the screen to page 3 in Standby mode. Page 3 is
Maintenance Menu
. Tap
Setting
to enter
setup menu. For system with T Pack, check
“
√
in the red box before
Tank Recirculation.
Notes: Maintenance menu is password protected for system administrators. The log-in
information is in the USB stick shipped with the system.
This completes the system hardware installation.
