Gel Imagers
7
Insert and tighten the knob/washer in the
central hole in the camera to secure the
camera to the bracket.
Plug the camera cable into the top the
camera and the other end into a UBS port on
back of the darkroom
.
Connect the jumper cord from the darkroom
to the transilluminator.
Connect the main power cord from the back
of the darkroom to a surge protector power
outlet.
Printer Set-up
The thermal printer is an optional accessory. Proceed to the next section if a printer was not included with
the shipment.
Stylus and Holder
The screen is touch sensitive. Use the stylus included with the system to operate the software controls. For
easy access to the stylus when operating the system, remove the tape from the back of the holder and
adhere it to the Gel Imager. Slide the stylus into the holder.
Connection
for jumper cord
to the
transilluminator
Connection for the
darkroom power
USB port
