DETAIL A
UPPER LEFT CORNER OF SCREEN
DETAIL B
UPPER RIGHT CORNER
OF SCREEN
DETAIL C
BOTTOM RIGHT CORNER
OF SCREEN
VUTEC CORPORATION
DRAWN BY
REVISED
DESCRIPTION
DRAWING NO.
SCALE:
REV
11711 W. SAMPLE RD. CORAL SPRINGS, FL 33065
THE INFORMATION
CONTAINED IN THIS
DRAWING IS THE SOLE
PROPERTY OF VUTEC
CORPORATION AND
REPRODUCTION IN PART
OR AS A WHOLE WITHOUT
THE WRITTEN
PERMISSION OF VUTEC
CORPORATION IS
PROHIBITED
ASSEMBLY INSTRUCTIONS
SILVERSTAR PANOFLEXX
SILVERSTAR\FLEX\
ASSEMBLYINSTRUCTIONS
NONE
--
PG - 9
ASSEMBLY INSTRUCTIONS:
1.
REMOVE THE TOP O-RING FROM THE UPPER LEFT CORNER
BRACKET.
2.
FORM A LOOP IN ONE OF THE ENDS OF THE FIRST BUNGEE
CORD. TIE A DOUBLE KNOT TO SECURE.
3.
PUT THE LOOP ON THE SECOND OR THIRD LACING POST
FROM THE UPPER LEFT CORNER.
4.
BRING THE FREE END OF THE CORD OVER THE LACING
POSTS TO THE CORNER BRACKET. STRETCH THE CORD
USING 5-10 LBS OF FORCE AND WRAP IT AROUND THE STUD
IN THE CORNER TWICE AS SHOWN IN DETAIL A.
5.
THREAD THE FREE END THRU THE FIRST GROMMET.
6.
FORM A LOOP IN THE BUNGEE APPROXIMATELY WHERE THE
SECOND GROMMET IS AND PUSH IT THRU THE GROMMET.
PUT THE LOOP OVER THE FIRST LACING POST FROM THE
END.
7.
MAINTAINING ENOUGH TENSION TO PREVENT THE FIRST
LOOP FROM SLIPPING OFF OF THE LACING POST, REPEAT
STEPS 5 AND 6 FOR THE NEXT GROMMET.
8.
REPEAT STEP 7 FOR THE REST OF THE POSTS ON THE TOP
OF THE SCREEN.
9.
WHEN YOU REACH THE UPPER RIGHT CORNER, REMOVE THE
O-RINGS AND CONTINUE LACING UNTIL YOU REACH THE
LOWER RIGHT CORNER.
10.
AT THE LOWER RIGHT GROMMET PULL THE BUNGEE THRU
AND, WHILE MAINTING TENSION, WRAP IT AROUND THE
CORNER BRACKET POST TWICE.
11.
REPEAT STEP 2 FOR THE FREE END OF THE CORD AND
SECURE TO THE SECOND OR THIRD LACING POST FROM
THE BOTTOM. THE END SHOULD HAVE SOME TENSION ON
IT. IF IT IS LOOSE, UNDO THE KNOT AND FORM THE LOOP
FURTHER DOWN ON THE CORD. DO NOT CUT OFF EXCESS
CORD.
12.
REPEAT FOR THE SECOND BUNGEE CORD, STARTING FROM
THE OTHER LACING POST ON THE UPPER LEFT CORNER
BRACKET.
ASSEMBLY STEP 6: LACE THE SCREEN
ATTACH THE START LOOP
TO EITHER OF THESE
POSTS.
START HERE FOR FIRST
LACING SECTION (STEP 1)
START HERE FOR SECOND
LACING SECTION (STEP 12)
D.TALLMAN
04/05/2019
