BACK VIEW LOOKING FORWARD
SEC.- A-A
DETAIL B
DETAIL C
A
A
B
C
VUTEC CORPORATION
DRAWN BY
REVISED
DESCRIPTION
DRAWING NO.
SCALE:
REV
11711 W. SAMPLE RD. CORAL SPRINGS, FL 33065
THE INFORMATION
CONTAINED IN THIS
DRAWING IS THE SOLE
PROPERTY OF VUTEC
CORPORATION AND
REPRODUCTION IN PART
OR AS A WHOLE WITHOUT
THE WRITTEN
PERMISSION OF VUTEC
CORPORATION IS
PROHIBITED
HALF OF FRAME
ASSEMBLY INSTRUCTIONS:
1.
FIT THE FRAME TO THE WALL AREA THAT IT WILL BE
ATTACHED TO.
2.
USE #10 OR #12 SIZE FASTENERS IN THE SLOTS TO ATTACH
THE WALL BRACKETS (ITEM 4) TO THE WALL IN THE
LOCATION INDICATED ON THE CUSTOMER DRAWING.
ENSURE THAT THE TOP RAIL OF THE FRAME IS LEVEL.
3.
THE FRAME SHOULD BE IN TENSION WHEN INSTALLED. IF
THE FRAME IS LOOSE ON THE BRACKETS, REMOVE THE
FRAME AND ADJUST THEM UNTIL IT IS SECURE AND DOES
NOT SLIDE EASILY ON THE WALL.
4.
REMOVE THE FRAME FROM THE WALL AND MARK THE
LOCATION OF THE CENTER HOLE OF THE BRACKETS.
5.
PERMANENTLY SECURE THE BRACKETS TO THE WALL USING
THE CENTER HOLE.
6.
IT IS THE INSTALLER'S RESPONSIBILITY TO SECURE THE
WALL BRACKETS TO THE WALL USING THE APPROPRIATE
HARDWARE.
FRAME
REFER TO CUSTOMER DRAWING FOR ALL DIMENSIONS
MOUNTING BRACKET LOCATIONS ON CUSTOMER DRAWING ARE
APPROXIMATE. CENTER BRACKETS MUST REMAIN CENTERED BUT
EDGE BRACKETS MAY BE MOVED UP TO EIGHT INCHES FROM
LOCATIONS INDICATED.
SCREEN
CENTER
3 1/4
3 1/4
3 1/4
ASSEMBLY INSTRUCTIONS
SILVERSTAR PANOFLEXX
SILVERSTAR\FLEX\
ASSEMBLYINSTRUCTIONS
NONE
--
ASSEMBLY STEP 3: MOUNT WALL BRACKETS AND TEST FRAME FIT
DO NOT INSTALL THE SCREEN MATERIAL YET.
USE THESE SLOTS TO SET
THE FRAME POSITION.
SECURE THE BRACKET USING THIS
HOLE AFTER BRACKETS ARE IN
FINAL POSITION.
PG - 6
D.TALLMAN
04/05/2019
