Vulcan-Hart ERC50, Руководство по обслуживанию

Страница: 22 / 48

ER SERIES ELECTRIC FRYERS - SERVICE PROCEDURES AND ADJUSTMENTS
F35613 (September 2003) Page 22 of 48
PROGRAM
ITEM
KEY SEQUENCE
LED
STATUS
DISPLAY
8
ON OFF LEFT RIGHT
More Service
Programming
Level
• Press 8 to enter the More Service
Programming. To edit one of the selections,
enter the 2-digit number desired. To exit a
selection, press V to accept & return to More
Service Programming. 4, 5,
6, 7,
8
MORE SERVICE
• Press 4 to view or edit the Shake Alarm
duration: 0-98 seconds; 99 - continuous
alarm until cancelled manually. DT-DUR 13 DURATION
• Press 5 to view or edit the Hold Alarm
duration: 0-98 seconds; 99 - continuous
alarm until cancelled manually. HD-DUR . • 05 DURATION
• Press 6 to view or edit the Cooking cycle
cancel delay; 0-10 seconds.
3
CANCEL .
•
01 DELAY
• Press 7 to view or edit the number of basket
lifts: 0 = none; 1 = one lift; 2 = two lifts.
4, 5
all LIFTS 0 , 1 or 2
• Press 8 to view or edit the fryer
<
s Energy
Source, electric or gas heat.
5, 6
all FRYER ELECTRIC or gAS
NOTES: 1. Oil temp LED’s cycle on/off with heat.
2. If the cooking temperature is below set point by this number, a cooking cycle can not be started.
3. The number of seconds to hold a product key during a cooking cycle to cancel it.
4. If zero basket lifts are selected, the idle setback option under ERC SERIES PROGRAMMING in the
Installation and Operation manual is not available.
5. Exit Service Programming Mode. Cycle power switch to lock selection into memory.
6. Pressing V to accept selection returns menu to Operator Programming & not More Service
Programming. Enter Service Programming Mode again, to make additional selections.
7. Default melt cycle on/off times shown for liquid shortening (default shortening type).
8. Default value shown in bold.
Display, Led and Keypad Test
1. Press and hold the 5 key while turning power
on to Initiate test. Release the 5 key during
display of software revision level.
2. For each number key (1-9, & 0) pressed, the
corresponding value is displayed in each
character position on the left and right display.
(i.e. 5 key shows 55555555 55555555).
NOTE: Beeper chirp’s for as long as key is held.
3. For each function key pressed, the following
values are displayed in each character position
on the left and right display:
- PROGRAM (V): V
- TEMPERATURE: T
- TOGGLE: L
- BOIL: B
- LEFT TIME: <
- RIGHT TIME: >
4. Turn power off to exit test.