Vulcan-Hart 039-8438, Инструкция по эксплуатации

Страница: 8 / 16

8
3. The adjuster plate can be moved up and down
when twisting the adjuster nut ( B, fig. 4) .
According to the length of nail, the adjuster
plate should be adjusted correctly to the posi-
tion indicated inside the lower nail housing.
4. Place a coil of nails over the lower nail housing. Uncoil
enough nails to reach the feed hook and place the
second nail between the teeth on the feed hook
( Fig. 4A ).
5. Close the magazine cover. Close and latch the feeder
cover.
6. Adjust the directional exhaust defl ector so that the
exhaust air will be directed
away from the operator. Grasp the defl ector and rotate it to the desired
position.
7. Adjust the shingle guide by loosening the retaining screw and sliding
the shingle guide to the desired position. Tighten the retaining screw
firmly. (The shingle guide can be used as an aid in positioning the
shingle to be nailed at a specific distance from the front edge of the
previous row of shingles.)
2. Press down latch, open feeder cover and upper nail
housing ( A, fig.3 )
CAUTION
!
l
Disconnect tool from the air supply.
l
Keep the tool pointed away from yourself and others at all times.
l
Do not load fasteners with safety or trigger depressed.
l
Always wear approved safety glasses and hearing protection when preparing or
operating this tool.
l
Never use a tool that leaks air or needs repair.
LOADING FASTENERS
1. After reading and understanding this entire manual,