10
MAINTENANCE
CAUTION
!
Disconnect the tool from the air supply before cleaning and
inspecting the tool. Correct all problems before operating.
CLEAN AND INSPECT DAILY
=
Add pneumatic tool oil into the oiler regularly to assure that all moving.
Frequent, but not excessive lubrication is required for the best performance.
Oil added through the air line connection will lubricate the inside parts. An
automatic oiler is recommended, but 5 to 6 drops of oil may be added manually
into the tool’s air intake at the male quick-connect fitting (
F, fig.1
) at the
beginning of each workday and after about every hour of continuous use. Only
a few drops at a time are necessary. More than this will pool inside the tool
and be expelled from the tool’s exhaust during firing.
USE ONLY PNEUMATIC
TOOL OIL
. Do not use detergent oil or oil with other additives, as these can
cause accelerated wear on the seals.
=
Check the filter of the compressor weekly. Open drain cock to drain all water
and contaminants out of the air tank.
=
Wipe the tool clean.
=
Blow the tool clean using high compressed air, and then use non-flammable
cleaning solutions to wipe exterior of tool if necessary.
=
Do not soak tool in cleaning solutions. Such solutions can damage internal
CLEARING A JAMMED FASTENER
CAUTION
!
Disconnect the tool from the air supply.
1. Open the feeder cover and the magazine cover.
2. Remove any remaining fasteners from the nailer.
3. Use a slender, soft steel rod to push the drive blade to its uppermost position.
4. Remove the jammed fastener with needle nose pliers.
5. Follow instructions in
LOADING FASTENERS
to reload fasteners.
CAUTION
!
=
Keep the tool pointed away from yourself and others at all times.
=
Always connect the tool to air supply before loading fasteners.
=
Do not load fasteners with safety or trigger depressed.
=
Always wear approved safety glasses and hearing protection when preparing
or operating this tool.
=
Never use a tool that leaks air or needs repair.
Содержание 039-8438
Страница 16: ...16 SCHEMATIC DRAWING...
