Vulcan-Hart 039-8438, Инструкция по эксплуатации

Страница: 7 / 16

7
OPERATION AND USE INSTRUCTIONS
WARNING
!
BE SURE THAT YOU READ, UNDERSTAND
AND FOLLOW THE SAFETY RULES THAT ACCOMPANY THIS
MANUAL. THIS WILL ALLOW FOR BEST USE AND MAXIMUM
USER SATISFACTION.
The Vulcan Model 039-8438 is a light duty, coil fed, pneumatic nailer, using
compressed air as a power source. It is designed to install 7/8”– 1-3/4”, 11 ga.
(0.120”) flat, full round-head roofing coil nails in 120 nail, 15 degree wire-collated
rolls. The tool is made with a magnesium alloy body and cylinder cap to provide
light weight while maintaining high strength and rigidity.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 70 - 120 psi (max. 120 psi). The preferred system would include
a filter, a pressure regulator, and an automatic oiler located as close to the tool as
possible. (Within 15 ft. is ideal). All compressed air contains moisture and other
contaminates that are detrimental to internal components of the tool. An airline filter
will remove most of these contaminates and significantly prolong the life of the tool.
If an in-line oiler is not available: place 5 or 6 drops of oil into the tool’s air inlet at
the beginning of each workday.
Nailer
Air hose Regulator
Oiler
Filter
Air Supply
WARNING
!
l
All line components (hoses, connectors, filters, regulators, etc.) must meet
150% of the maximum system pressure. Please try to use a hose of ID 3/8”
connecting nailer with compressor.
l
Do not connect this tool to a system with maximum potential pressure greater
than 180 psi.
l
Disconnect your air line from your nailer using the quick connect on the air
hose. Do not unscrew the air inlet from the nailer with your air hose connected.
l
Disconnect the tool from the air supply before loading fasteners, performing
maintenance, clearing a jammed fastener, leaving the work area, moving the
tool to another location, or handing it to another person.