Vulcan Attachments V3GS, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 35

8) Stop the breaker quickly.
a. Do not allow the breaker to fall off the
object or make idle strokes when the object
breaks. Constant idle strokes have a
deteriorating effect on the breaker.
b. If the breaker falls off the object ,side
pressure could occur, and side plates will
be worn down more quickly
9) Chisel, cone, and moil

If the object does not break after fifteen
seconds, stop the beaker and change the
position of the tool. Leaving the tool in the
same position for more that fifteen seconds
will only make an indentation, which will fill
with dust and dampen the impact effect. This
will cause the tool to overheat.
10) When breaking concrete, hard ground, frozen
ground, or any similar material, never strike and
pry with the tool at the same time. This could
break the tool.
2.5 Operating Temperature

The operating temperature is -20°C~80 ⁰ C. If the
temperature is lower than -20°C (-4°F), the
breaker and tool must be preheated before
starting to operate, in order to avoid breakage of
the accumulator membrane and the tool.
During operation they will remain warm.
2.6 Important Operation Points
a. Listen to the breaker‟s sound while you are
working.

If the sound becomes thinner and the impact
is less efficient, the tool is misaligned with
the material and/or there is not enough
“pressing” force on the tool.

Realign the tool and press the tool firmly
against the material.
b. The breaker, as a standard assembly must
not be used underwater.

If water fills the space where the piston
strikes the tool, a strong pressure wave is
generated and the breaker could be
damaged.